Other operating instructions, For a rinse and spin, For a soak or pre-wash – Whirlpool LT4905XM User Manual
Page 10: For a drain and spin, Cleaning the lint niter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
permanent
press
For a rinse and spin
You may need an extra rinse and
spin tor heavily soiied loads which
need more detergent. (Extra de
tergent can require an extra rinse.)
• Push Controi Knob in.
• Turn clockwise to any *on the diai.
See above drawing.
• Pull Control Knob out.
• The washer will fill to selected level
with cold water, agitate
2
minutes,
drain and spin.
For agitation and spin speeds
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing soiled
laundry.
For a drain and spin
Your washer can be set to drain
and spin out water.
• Push Control Knob in.
• Turn ciockwise to the bar just before
OFF. See above drawing.
• Pull Control Knob out.
• The washer will drain and spin.
in each cycle, see pages
8
and 9.
Use enough detergent or pre-soak
product for a single load.
Push Control Knob in.
Turn clockwise to point at a number
in the SOAK Cycie.
Puil Controi Knob out.
When the cycle Is over, add de
tergent for the next selected wash
cycle. Important: See additional
care intormation on page 7 of your
“Laundry Guide.”
Set the washer and startthenext
selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Cleaning the lint niter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc
tions for Cleaning are printed on the
bottom of the filter.
10