Select cycle and wash time; 4. start the washer, Select cycle and wash time, Start the washer – Whirlpool LT4905XM User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To hold the washer lid up, lift the lid
until it snaps past the latch.
To release the lid, push the lid
latch up.
Select CYCLE and WASH TIME;
4
.
Start the washer
A.
Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
Stop on a number in the cycle
you want. The numbers are
minutes of wash time The
drawing shows 8 minutes of
agitation in the REGULAR HEAVY
Cycle.
C.
start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes
D.
To stop the washer at any time,
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
To set the controls for
a
rinse and spin,
a drain and spin, or a soak or pre
wash, see page 10.