Recessed and closet, Installation, Instructions – Whirlpool LTE5243DQ User Manual
Page 8: Product dimensions, Recessed and closet installation instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recessed and closet
installation
instructions
This washer/dryer may be installed in a
recessed area or closet.
The installation spacing is in inches and
is minimum allowable, Additional
spacing should be considered for ease
of installation, servicing and compliance
with local codes and ordinances,
If closet door is installed, the minimum
unobstructed air openings in top and
bottom are required. Louvered doors
with equivalent air openings are
acceptable. Closet installation must be
exhausted.
Other installations must use the minimum
dimensions indicated.
Recessed and closet
installation
instructions
Recessed installation
Product dimensions
Most installation will require at least 5 inch
clearance behind the dryer for the dryer vent.
Location must be large enough to fully open dryer
door.
(Shown with legs extended 1 inch from
bottom of washer/dryer.)
Minimum installation spacing
Note: If recessed installation is exhausted, all
spacing can be 0 Inches.
Additional clearance for wall, door and floor
molding may be required.
Recessed, non-exhausted installation must use
only the rear exhaust position and Exhaust
Deflector Kit Part No. 694609 is required.
Closet installation
Closet Installation must be exhausted outdoors.
Panel G