GE 45115 GE Personal Security Window or Door Alarm 2 pack User Manual

Warning, A warning, User's manual

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image







(Alsmi is activated when switched ON and gap between
alarm and magnetic sensor is greater than 0.5"]


The Magnetic Window Alarm reguires (4) L044

button batteries (included). Average battery life
for typical usage is 1 year.

1. Slide cover off the battery compartment located

on the front of the main unit.


2. Push the 'Battery Test' pushbutton in the battery

compartment. If the green light illuminates, the
battery is still good. If it fails to illuminate,
replace all batteries.

3. Insert (4) LR44 button batteries noting polarity.
4. Replace battery compartment cover.


Remove batteries before storing the

Alarm for extended periods. Batteries corrode over
time and may cause permanent damage to the unit.

Different types of batteries or new and used batteries

should not be mixed. Depleted batteries should be
removed from the unit and disposed of properly.


Using the double sided adhesive tape provided,
mount the alarm and magnetic sensor on window,
door, or cabinet to be protected, placing one of the
units on the part of the fixture that opens (window)

and the other unit on the stationary part of the fixture
(frame). Mount so that when the window, door or
cabinet is closed, the gap between the alarm and
sensor is no more than 0.5" (preferably less).



1. To arm the unit, slide cover off the battery

compartment located on the front of the main
unit. Toggle ON/OFF switch to the ON position.

The window on the housing will become red.

Replace battery compartment cover. Whenever

the protected window, door or cabinet is opened
(causing the alarm to be separated from the

magnetic sensor by more than 0.5"), the alarm
siren will sound continuously until disarmed.

2. To disarm the unit, slide cover off the battery

compartment. Toggle ON/OFF switch to OFF
Position. Make sure the window, door or
cabinet is closed before rearming.


To test, a cloth can be used to cover

the alarm to reduce risk of hearing damage.


To clean the unit housing, use a soft cloth slightly

dampened with water and wipe dry. Do not use
chemical agents as this may damage and
discolor the unit.



Limitations of Alarm Products

This product should be tested weekly to make sure it is working

properly. The product, if used properly, may reduce the risk of
burglary, robbery, fire, or other adverse events. However,

JASCO is not an insurer, this product is neither insurance nor a

guarantee that such an event will be prevented, and users
should protect themselves with proper insurance. JASCO
makes no representation that this product cannot be
compromised or circumvented, that it will provide an adequate
warning, or that it will prevent any personal injuries, property
damage, or other losses. Like any alarm product, including
expensive commercial systems, it may be bypassed, it is subject

to compromise, and it may fail to warn for a variety of reasons,

including, but not limited to: improper installation or positioning;
improper maintenance: tampering; dead or improperly installed
batteries: sensing limitations; component failures; smoke may
not reach detectors; for wireless systems, the functional range
may be adversely affected by certain environmental conditions,
radio frequency interference and obstructions between the

transmitters and receivers; for systems using telephone lines,
the lines may be out of service or disrupted; for infrared

products, intrusions may be outside of a product's designed
range and certain environmental conditions may impact


performance and audible alarm signals may be outside of
hearing range, muted by doors, walls, and floors, unheard by
deep sleepers or the hearing-impaired, or overwhelmed by
other sounds.


Jasco Products Company warrants this

productto be free from manufacturing defects for a period of ninety days

from the original date of consumer purchase. This warranty is limited to the

repair or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be used with

this unit This warranty is in lieu of all other warranties express or implied.
Some states do not allow limitations on how long an implied warranty lasts

or permit the exclusion or limitation of incidental or consequential damages,
so the above limitations may not apply to you. This warranty gives you
specific rights, and you mayalso have other rights whichvary from state to
state. If unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:

Jasco Products Company
311 N.W. 122nd

Oklahoma City, OK. 73114

Magnetic Window Alarm

User's Manual

For Indoor Use Only
Do Not Use in Wet Locations

is a trademark of General Electric Company

and is used under license to

Jasco Products Company LLC,
311 N.W. 122nd Street,

Oklahoma City, OK 73114
Or visit us at







Risk of personal injury

• Prolonged exposure to alarm siren


Batteries may leak harmful liquids
or ignhable materials or explode
causing injury and product damage

• Do not mix old and new or

other battery types

• Replace all oatteriesatthe

same time

• Replace fully discharged

batteries immediately

Table of contents