Replacing the surface light, Removing and cleaning the filters, Replacing the oven cavity lamp – GE CSA1201RSS User Manual

Page 35: Саге and cleaning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Саге and Cleaning

Advantium Oven

Replacing the

surface light

1. To replace the surface light, first

disconnect the power at the main fuse
or circuit breaker panel or unplug the
oven.

2. Remove the screw from the side of

the light compartment cover and lower
the cover until it stops.

3. Be sure the bulb to be replaced is
cool before removing. Gently pull the
bulb from the receptacle.

Replace with a 130 volt, 50-watt
halogen bulb. Order WB08X10051
from your GE supplier.

4. Raise the light cover and replace
the screw. Connect electrical power to
the oven.

Remove screw

Removing

and cleaning

the filters

1. The metal filters trap grease

released by foods on the cooktop.

They also prevent flames from
foods on the cooktop from

damaging the inside of the oven.

2. For this reason, the filters must

always be in place when the hood
is used. The vent filters should
be cleaned once a month, or as
needed.

3. To remove, slide them to the rear

using the tabs. Pull down and out.

4. To clean the vent filters, soak them

and then swish around in hot water
and detergent. Don't use ammonia
or ammonia products because
they will darken the metal. Light
brushing can be used to remove
embedded dirt.

5. Rinse, shake and let dry before

replacing.

5. To replace, slide the filters into the

frame slots on the back of each
opening. Press up and to the front
to lock into place.

Replacing the

oven cavity

lamp

1. Disconnect power at the main fuse

or circuit breaker panel.

2. Remove the top grill by removing

the two screws that hold it in place.

3. Remove charcoal filter if present.

Slide the filter toward the left and
pull toward the front to remove.

NOTE:

Charcoal filter is an optional

kit, you may not have one.

4. Remove the screw holding the lamp

shield in place.

5. Pull the lamp shield out. Pull the

light bulb out and replace with the

120V-130V, 20-watt halogen bulb.

Order WB25X10019 from your GE
supplier.

5. Return the lamp and lamp shield to

original position and replace screw
and charcoal filter.

7. Replace the grill and 2 screws.

Reconnect power to the oven

35

Advertising