About the washer features, Cycle signal, Extra rinse – GE LAVEUSES GBVH5140 User Manual
Page 8: Delay start, Lock, Signal, Pre wash
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
.o
'ft
I
-1
è"
c/s
About the washer features.
NOTE: Features may not be available on all washer models.
*)| SIGNAL
Cycle Signal
Use the
SIGNAL
button to diange the
volume of the end of cycle signal.
Press the button until you l each the
desired volume.
PRE WASH
Prewash
(on some models)
Prewash is an extra wash before the
main wash. Use it for hea\ily soiled
clothes or for clothes with a care label
that recommends jaiew'ashing before
w'ashing. Be sure to add high-efficiency
detergent, or the jrrojrer w'ash additive
to the prewash dispenser.
NOTE:
When selecting prewash, it is
recommended to use powder detergent in the
main wash (detergent) compartment.
o
EXTRA
RINSE
Extra Rinse
Use an extra rinse when additional
rinsing is desired to remove excess dirt
and determent from soiled loads.
Delay Start
You can delay the start of a wash eyrie for
up to 18 houre on models GHDVH626,
GCVH6260, WCVH6260, WBVH6240,
WHI)VH626, WCY'HeeOO, WHDVH660,
GCVH6600 and GHDVH670, and for up
to 10 hourt on models WBVH.il 00 and
GBVH.5140. Press the
DELAYSTART
button to choose the nmnbei’ of houis
you want to delay the stait of the cycle,
then press the SMfirbutton. The
machine will count down and start
automatically at the coriect time.
NOTE:
If you forget to fully close the door, a
reminder signai will beep reminding you to do so.
NOTE:
If you open the door when the delay
is counting down, the machine will enter the
pause state. You must close the door and press
START
again in order to restart the countdown.
(D
H0L03SÈC
to LOCK
C
ontrol
Lock
You can lock the controls to prevent any
selections horn being made. Oi’ you can
lock the controls aftei' you have staited a
cycle.
Children cannot accidentally start the washer
by touching pads with this option selected.
To lock the washer, jaress and hold the
lock button for 3 seconds. To unlock the
w'asher controls, press and hold the lock
button for 3 seconds.
The control lock icon on the disjjlay will
light up when it is on.
NOTE:
The POWER button can still be used
when the machine is locked.
HOLDS see {
lyiY CYCLE#)
8
MY CYCLE
(on some models)
To save a favorite q cle, set the desired
settings for wash cycle, soil level, spin speed
and wash temp settings and hold down the
MY
CYCif button for 3 seconds. A beep will
sound to indicate the qcle has been saved.
To use )'our custom cycle, press the
MY
CYCif button betoie washing a load.
To change the saved cycle, set the
desired settings and hold down the
MY CYCLE button
for 3 seconds.
NOTE:
When using MY CYCLE, wash
options cannot be modified after the cycie
has been started.
NOTE:
If you change wash options with
MY CYCLE
before starting the cycle, the
MY CYCLE
light wilt turn off and you will
be returned to the base cycle.