GE 2-9910 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IN CASE OF
DIFFICULTY
In case of difficulty,
PROBLEM
check the Troubleshooting Chart below before seeking service.
No Dial Tone
1. Check Installation:
— Is
BASE POWER CORD
connected to a working outlet?
— Do not use an outlet that can be turned ON and OFF by a wall
switch.
— Is
TELEPHONE LINE CORD
connected firmly to the base unit
and phone outlet?
— is
BASE ANTENNA
raised?
2. is
CORDLESS HANDSET
out of range of the base?
3. маке sure
BATTERIES
are properly charged (12 Hours).
4. Is the
BATTERY PACK
installed correctly (see page 19)?
5. Did the
CORDLESS HANDSET
beep when you pressed the phone
button? Did the phone light come on? If not, your cordless may
need to be, charged.
6.
Disconnect
CORDLESS PHONE
and connect another phone to the
same jack. If no dial tone, then the problem may be in your wiring
or local service.
7. Reset security code by placing handset in base unit, (see page 9)
Dial Tone but can’t
dial out
8.
If you have pulse service on your line, your
TONE/PULSE
Switch on
the Base must be set on Pulse.
Handset does not
ring
9.
Make sure
RINGER
Switch on Handset is “ON”.
10. Do you have too many extension phones on your telephone line? Try
unplugging some other phones.
11. Perform checks 1,2,3,4,5,6 and 7 above.
You experience
static, noise, or fading
in and out
12. Try changing the channel, (see page 14)
13. Is
BASE ANTENNA
raised?
14. Is
HANDSET out
of range from the
BASE?
Move closer to
BASE.
15. Does the
BASE
need to be relocated?
16. Is
CORDLESS BASE
plugged into an outlet with household
appliances? If so, move the appliance or telephone.
17. Check installation per #1 above.
nhoroo RATTFRY
for
1? hours.
4^1 lUJ у 1*
"W.
19. Clean charging contacts on
HANDSET
and
BASE
with a soft cloth.
20. Check installation per #1 above.
21. Replace
BATTERY.
______________
Memory
Dialing
Problems
22. Did you program the memory correctly (see page 17)?
23. Did you follow proper dialing sequence (see page 17)?
24. See above.
25. Did you reprogram numbers into memory after power outage? (See
P
pop
17^
21