Ililiu, Oderatinq the clock radio – GE 1-Jul User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Wake

10*00

ILILIU

NAP

Setting the WAKE Time

Your digital clock operates on a 12 hour
standard mechanism,

1, Press the SET button untii WAKE 1 /

WAKE 2 icon is biinking.
2, Press REV C] or FWD ta to set the wake

time. The time decrements or increments

wiil foliow by a faster rate when you press

and hold either REV c3 or FWD Ca.
3, After the WAKE time is set, press SET

repeatediy until no icon is blinking.

Tip;

The unit equips with SflAb-U-WAKE

feature, the donn tone volume will increose
gradually to its maximum in about 30 to 45
seconds.

Tip:

If you set the SLEEP function with low
volume level before going to bed, we advise

using WAKE mode to wake you up since
its volume will automatically increase.

Waking by Selected Source

You may be woken up by WAKE "i, RADIO

d or CD

1. Select an AM or FM station.

2. Set wake time (see above directions).
3. Press WAKE 2 or WAKE 1 to select wak­

ing up by WAKE it,

radio

d or CD 0,

Corresponding indicator will be up next
to the selected setting.
4. Adjust the volume by turning VOLUME.

You can select your CD wake track by the
following procedures.

1. Press WAKE UP CD TRACK.

2. While pressing, press REV crlJ or FWD

Ca to select your desired CD wake up track.

Mote;

When you turn off the alarm by pressing

OFF, the alarm will turn on at the Some

time tomorrow.

ODeratinq the Clock Radio

Sleep Mode

In sleep mode, the radio or CD will turn

off automatically. Simply:

1. Listen to CD or radio.

2. While holding SLEEP, press REV C] or

FWD ta to set the sleep time. The time
range is from 1 minute to 2 hours.
3. Release SLEEP and the current time will
be shown again. The radio or CD will turn
off when the preset time elapses. If you
decide to turn off the radio or CD sooner,

press SNOOZE or OFF.

4. When SLEEP is activated again, the sleep
time will be the same as the one you have
set before,

5. Press SLEEP to read the remaining sleep

time.

Nap Mode

This function wakes you up after a short

period of time. Simply:

1. Press NAP and release. The NAP indica­

tor will flash. During this period, adjust

NAP time by pressing REV dor FWD CSt.

The range is from 10 minutes to 2 hours.

2. The clock will be shown after 5 seconds
if no button is pressed. The

nap

indicator

will lit up.
3. Press NAP once to show time left.

Stop the Nap alarm

Press NAP or follow "Turning off Alarm".

1. Press and hold NAP to cancel the nap

setting,
2. Only alarm sound can be selected.
3. Nap alarm is equipped with GRAD-U-
WAKE feature.

Turning off Alarm

Silence the alarm momentarily

Press SNOOZE. The alarm will sound again

when the snooze period is over, (See

"Snooze Alarm Operation").

Stop the alarm

Press OFF. The alarm will sound on the

following day at the same time.

Disable the alarm permanently

1. Press CANCEL.

2. The WAKE indicator will be flashing.
3. Press WAKE 1 or WAKE 2 within 3

seconds to deactivate the corresponding

alarm function permanently.

Tip:
You can activate the previously set alarm
time by pressing

WAKE 1

or

WAKE

2

Advertising