Customer responsibilities, Product specifications, Warning – Kenmore 153:331472 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CUSTOMER RESPONSIBILITIES

Thank You

for purchasing a Kenmore water heater. Properly installed

and maintained, it should give you years of trouble free service. If

you should decide that you want the new water heater professionally

installed by Sears call 1-800-4-MY-HOME®. They will arrange for

prompt, quality installation by Sears authorized contractors.

Abbreviations Found in This instruction Manuai:

Carefully plan the place where you are going to put the water heater.

Correct combustion, vent action, and vent pipe installation are

very important in preventing death from possible carbon monoxide

poisoning and fires. See Figure 1.
Examine the location to ensure the water heater complies with

the

Installation Instructions

section in this manual.

• CSA- Canadian Standards Association
• ANSI - American National Standards Institute
• NFPA- National Fire Protection Association
• ASME - American Society of Mechanical Engineers
• GAMA - Gas Appliance Manufacturers Association

Important Information About This Water Heater:

This gas water heater was manufactured to voluntary safety

standards to reduce the likelihood of a flammable vapor ignition

incident. New technology used in meeting these standards makes this

product more sensitive to installation errors or improper installation

environments. Please review the Installation Checklist found at the

end of the installation instructions section and make any required

installation upgrades or changes.
This manual contains instructions for the installation, operation,

and maintenance of the gas-fired water heater. It also contains

warnings through out the manual that you must read and be aware

of. All warnings and all instructions are essential to the proper

operation of the water heater and your safety. Since we cannot put

everything on the first few pages,

READ THE ENTIRE MANUAL

BEFORE ATTEMPTING TO INSTALL OR OPERATE THE WATER

HEATER.

• The installation must conform with these instructions and the

local code authority having jurisdiction. In the absence of local

codes, installations shall comply with the following:

In the United States:

The National Fuel Gas Code ANSI Z223.1/

NFPA 54. This publication is available from the Canadian

Standards Association, 8501 East Pleasant Valley Rd, Cleveland

Ohio 44131, or The National Fire Protection Association, 1

Batterymarch Park, Quincy, MA 02269.

• If after reading this manual you have any questions or do not

understand any portion of the instructions, call the Sears Service

Center.

For California installation, this water heater must be braced,

anchored, or strapped to avoid falling or moving during an

earthquake. See instructions for correct installation procedures.

Instructions may be obtained from California’s Office of the

State Architect, 1102 Q Street, Suite 5100, Sacramento, CA

95811. Instructions can also be downloaded to your computer

at www.dsa.dgs.ca.gov/Pubs.

Massachusetts Code requires this water heater to be installed in

accordance with Massachusetts 248-CMR 2.00: State Plumbing

Code and 248-CMR 5.00.
Complies with 40 Ng/J NOx requirements of Texas and most

California AQM Districts.

A

WARNING

Excessive Weight Hazard

Use two or more people to move and install the water heater.

Failure to do so can result in injury (including back injury).

IMPORTANT: Do not remove any permanent instructions, labels, or

the data label from either the outside of the water heater or on the

inside of water heater panels.

• Remove exterior packaging and place installation components

aside.

• Inspect all parts for damage prior to installation and

start-up.

• Completely read all instructions before attempting to assemble

and install this product.

• After installation, dispose of/recycle all packaging materials.

PRODUCT SPECIFICATIONS

MODEL

NUMBER

TANK

CAPACITY

iN GALS (LTRS)

TYPE

OF

GAS

INPUT

RATE

(Btu/hr)

RECOVERY

RATE

GALS.

PER

HOUR

@ 90°F RISE

MINIMUM

VENT PIPE

DIA. INCHES

(mm)

DIAMETER

INCHES

(mm)

DIMENSIONS

INCHES (mm)

HEIGHT TO

JACKET TOP

153.331472

40 (151)

Naturai

40,000

40.9

3(76) OR 4 (102)

20 (508)

58.14 (1477)

153.331572

50 (189)

Naturai

40,000

40.9

3(76) OR 4 (102)

22 (559)

57.28 (1455)

Advertising