Load thread on the bobbin, Load thread on the bobbin -10 – Kenmore SWA/RS 14501 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Prepare the bobbin
Load Thread on the Bobbin
1. Disengage the clutch by turning the clutch
knob toward you.
2. a. Put a spool of thread on the spool pin.
b. Draw the thread from the spool through
the thread guide.
3. a. Wind the thread around the bobbin
several times in the direction of the
arrow.
Place the bobbin
winder shaft.
onto the bobbin
b. Start the machine by pressing down on
the foot control.
NOTE: The bobbin will stop turning when
it is filled.
5. a. Push the shaft to the left.
b. Remove the bobbin from the shaft and
trim the end of the thread.
6
. Engage the clutch by turning the clutch
knob away from you.
4. a. Push the bobbin winder shaft to the
right until it clicks.