Installing machine 0 – Kenmore 1250 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Section I
Page 4
INSTALLING MACHINE
0
0
1. Loosen the two hinge screws under
holes in the rear edge of the machine
bed.
2. Raise hinge pins in the cabinet cutout.
3. Slip machine head onto the pins and
tighten hinge screws securely.
4.
Push the speed control plug onto
three-prong connector under the bed
plate. Lower machine head to front
cabinet flap.
6
.
7.
Plug the speed control cord into any
110-120
volt wall outlet.
Turn on power by pushing light an
power switch.
Screw spool pins firmly in place wUh
screwdriver. Place the plastic sp
holder onto the spool pin. Holder ana
pins are packed in the accessory o •
Advertising