Connecting machine to power supply, Before using your sewing machine, For your safety – Kenmore 200 User Manual
Page 10: Polarized plug, Flag mode-language selection
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
(T)
Power supply plug
(2) Power switch
(D Outlet
® Red marker
(f) Foot control
® Foot control plug
® Machine socket
1. Turn off the power switch (2). Insert the foot control plug
® into the machine socket
2. Insert the power supply plug ® into the outlet ®.
3. Turn the power switch (2) to turn on the power and
sewing lights.
Notes:
• Do not pul! the cords beyond the red marker ® on the
cords.
• If you turn off the power switch, wait 5 seconds before
turing it on again.
• Hold plug when rewinding into cord reel. Do not allow
plug to whip when rewinding.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
• When leaving the machine unattended.
• When attaching or removing any parts.
• When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit In the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.