Kenmore Sens-A-Clean 665.95829 - Manual (Page 46)

Troubleshooting
Most cooking problems are caused by little things you can find and fix without tools of any kind. Check the lists
below and on the next page before calling for assistance or service.
RANGE DOES NOT WORK
PROBLEM
Nothing works
CAUSE/SOLUTION
The oven does not work
• The range is not plugged into a properly grounded live outlet with the proper
voltage. (See Installation Instructions.)
• A household fuse has blown or a circuit breaker has been tripped.
• The control knob is not set correctly. Push in the control knobs before
turning them.
• The Oven and Cooktop Lockouts have been set.
• The electronic control is not set correctly. Refer to setting the electronic
oven control section. (See pp. 14-34.)
• A delay start has been set. Wait for the start time to be reached or cancel
and reset the control.
• The Oven Lockout has been set.
The surface cooking
zones will not work
Cannot boil on left front
surface cooking zone/
SURESIMMER™ feature
SURESIMMER will not
simmer
SURESIMMER surface
cooking zone does not
get hot enough
• A household fuse has blown or a circuit breaker has been tripped.
• The control knobs have not been set correctly. Push the control knobs in
before turning them to a setting.
• The cooking element is burned out. Call a Sears Service Center for
replacement or repair.
• The Cooktop Lockout has been set.
• Press the SURESIMMER button to OFF.
• Turn left front control knob to HI for a rapid boil.
• Turn left front control knob on between the SURESIMMER LO and 4 settings,
along with pressing the SURESIMMER button on.
• Turn left front control knob to “4”, along with pressing the SURESIMMER
button on.
WHEN SELF-CLEANING YOUR OVEN
PROBLEM
The Self-Cleaning cycle
will not work
CAUSE/SOLUTION
• START/ENTER has not been pressed.
• A delayed start has been set. Wait for the start time to be reached or cancel
and reset the control.
• The door is not closed all the way.
46