Kenmore 1430 - Manual (Page 24)

PRESSER FEET
SUPER-HIGH BAR TYPE
Simply drop the presser foot lock and
slip the foot away from the presser bar.
To aid you in the placement of the
presser foot, the presser foot lever can
raise the foot beyond the normal "up”
position. After the foot is placed on the
presser bar, lift the lock as high as it will
go to hold the foot securely.
SNAP-OI\l TYPE
Raise the presser bar to its highest
position by lifting the presser foot lever.
Press the toe of presser foot upward as
high as it will go and foot is released.
Place the desired foot on the needle
plate aligning the needle holes and lower
the presser foot lever. Press down on
presser iopt thumb screw until the
clamping shank snaps on the foot.
ONE-PIECE TYPE
Raise the presser bar to its highest
position by lifting the presser foot lever.
Loosen the presser foot thumb screw
and remove the foot.
Insert new foot from the front and
tighten the screw using the large
screwdriver to make certain the foot is
secure.
Fig.3
23