Kenmore 122.161249 - Manual (Page 5)

SAFETY INFORMATION
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or
any other enclosed area. The Kenmore Table Top Grill may be stored indoors if the LP gas cylinder is
removed and stored outdoors. The LP gas cylinder (not included) is threaded for connection directly to the
gas regulator supplied with this appliance. Care should be taken when threading the cylinder to the regulator
to engage threads correctly to achieve the proper and intended connection. When disconnecting or
connecting the gas cylinder, be careful that the regulator does not strike the grill, the ground, or any other
surfaces. Replace the protective cap over the threaded cylinder connection when removed from grill. If any
difficulty occurs when connecting or disconnecting the cylinder to the regulator assembly, contact your local
gas supplier for assistance.
When re-connecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection
should be inspected for damage and leak tested after each re-connection.
To leak test, make a soap solution of one part liquid detergent and one part water. You will need a spray
bottle, brush, or rag to apply the solution to the cylinder-regulator connection. Bubbles indicate leaks.
PACKAGE CONTENTS LIST
Part Description Quantity
1 Grill 1 set
2 Regulator 1 set
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present.
Compare parts with package contents list and diagram above. If any part is missing or damaged,
do not attempt to assemble, install or operate the product. Contact customer service for
replacement parts at 1-800-4-MY-HOME.
Your Kenmore Table Top Grill is pre-assembled. The only assembly required is
to connect the gas regulator into the grill.
Estimated Assembly Time: 5-8 minutes.
Tools Required for Assembly: Wrench (supplied).