B. reemove shipping strap, Fot i/omf benefit, Pull – Kenmore Automatic Washers User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B. REEMOVE SHIPPING STRAP
fot i/oMf Benefit
Removing the shipping strap is
necessary for smooth operation.
If the shipping strap is not
removed, the washer will make
excessive noise.
To prevent floor damage, set washer onto
cardboard before moving across floor.
Move washer close to its final location.
STEP 1.
Read, then remove the label
over the electrical plug and shipping strap.
STEP 2.
Pull the yellow shipping strap
completely out of the washer. There
should be three cotter pins on the end
of the shipping strap when it is pulled
out of the washer. The electrical plug is
attached to this shipping strap.
STEP 3.
Pull firmly to remove the
end of the shipping strap that remains
pinned to the back of the washer. This
will release the rear self-leveling legs.
PULL
Electrical plug
PULL
STEP 4.
Cut the shipping strap about
16 inches from plug end. Look for the
words “CUT HERE.” Discard end with
three cotter pins.
Slide remainder of
shipping strap from the electrical
plug.
You will use this to secure the
drain hose.
13