Kenmore Automatic Washers - Manual (Page 20)

OPERATING YOUR WASHER
fòr your
Senefit
To get the maximum cleaning and
fabric care from your washer, please
read and follow these instructions.
NOTE: The drawings in this section
show the basic features of all models
covered by this manual. Refer to the
supplied “Feature Sheet” for your
washer’s particular features.
A WARNING
Explosion Hazard
Never place items in the washer
that are dampened with gasoline
or other flammable fluids.
No washer can completely
remove oil.
Do not dry anything that has ever
had any type of oil on it (including
cooking oils).
Failure to follow these instructions
can result in death, explosion,
or fire.
STARTING YOUR WASHER
STEP 1. Add measured detergent
directly into washer basket. Then place
a load of sorted clothes in the washer.
STEP 2. (OPTIONAL STEP) If desired,
add measured liquid chlorine bleach to
the liquid bleach dispenser (see page 26).
STEP 3. (OPTIONAL STEP) If desired,
add measured liquid fabric softener to
the fabric softener dispenser (see page 27).
STEP 4. Close washer lid.
STEP 5. Set WATER LEVEL Control©
based on the size of your wash load (see
page 21).
STEP 6. Set the WATER TEMPERATURE
Control© (see pages 21 and 22).
STEP 7. Set RINSE OPTIONS Control ©
(see page 24).
STEP 8. Set SPEEDS ©Control
according to the type of fabric in the
load (see page 22).
STEP 9. Push the Cycle Selector
Control (Timer) Knob ©in and turn to
the right to desired setting (see page 23).
STEP 10. Pull the Cycle Selector Control
(Timer) Knob out. The dial will rotate as the
cycle progresses. The knob will not rotate.
STOPPING/RESTARTING
YOUR WASHER
• To stop the washer at any time, push
the Cycle Selector Control (Timer)
Knob in.
• Pull the knob out to restart.
WATER LEVEL WATER TEMPERATURE RINSE OPTIONS
Dvty • CJtnory '’Ua • AxM ‘‘ m
20