Kenmore 141.173373 - Manual (Page 22)

1. Open the Doors of cabinet. Puli out the LPG
Tank PuN-Out Tray. Place a 20 ib tank with
foot ring into the hole in the tray. See Figure
13a. Make sure the tank valve is in the OFF
positon.
2. Align the tank so the Tank Valve faces the
rear right corner of cabinet. Use the
5/16"x3-1/2'' Wing Bolt to secure gas tank
from rear of tray. See Figure 13a.
3. Check the Tank Valve to ensure it has proper
externa! mating threads to fit the Hose &
Regulator assembly provided (Type 1 connec­
tion per ANSI Z21.58b-2002). See Figure 13b.
4. Inspect the valve connection port of the Regulator
assembly. Look for damage or debris. Remove any
debris. Inspect Hosefordamage. Never use damaged
or plugged equipment.
5. Make sure ail Burner Knobs are in the OFF
position.
6. Connect the Hose and Regulator assembly to the
Tank valve (See Figure 13b). Hand tighten Quick
Coupling Nut clockwise to a full stop. DO NOT use a
wrench to tighten because itcoulddamagetheOuick
Coupling Nut and result in a hazardous condition.
7. Open the Tank Valve fully (counterclockwise). Use a
soapy water solution to check ail connections for
I eaks before attem pti ng to I i ght your gri 11. See "Check­
ing for LP Gas Leaks" on page 23. if a leak is found,
turn the Tank Val ve off and do not use your gri ii unti I the
leak is repaired.
^Connecting A Liquid Propane G as (LPG as)
Tank To Your G rill
Disconnecting A Liquid Propane Gas (LP Gas)
Tank From Your Griii
1. Turn the Burner Knobs and LP Gas Tank
Valve to the full OFF position. (Turn clockwise
to close.)
2. Detach the Hose and Regulator assembly from
the LP Gas Tank Valve by turning the Quick
Coupling Nut counterclockwise. See Figure 13b.
CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.
Figure 13a (LP G as m odel only)
Figure 13b (LP Gas model only)
22