Kenmore 790. 7260 - Manual (Page 21)

Care & Cleaning
General cleaning
Refer to the Cleaning recommendation table in the Care &
Cleaning section for more detailed information about
cleaning specific parts of the range.
A CAUTION Before manually cleaning any part of the
range, be sure all controls are turned OFF and the range is
COOL. The range may be hot and can cause burns.
A CAUTION I Ammonia must be rinsed before operating the
oven. Provide adequate ventilation.
Replacing oven light (some models]
A CAUTION Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear a leather­
faced glove for protection against possible broken glass.
The oven light is located at the rear of the oven cavity and
is covered with a glass shield held by a wire holder. The
glass shield protects the light bulb and must be in place
whenever the oven is in use.
Aluminum foil and utensils
A WARNING
I
NEVER cover any slots, holes or passages in
the oven bottom or cover an entire oven rack with materials
such as aluminum foil. Doing so blocks air flow through the
oven and may cause CARBON MONOXIDE poisoning.
Aluminum foil linings may trap heat, causing a fire hazard.
• Al uminum foil - Use of aluminum foil on a hot cooktop
can damage the cooktop. Do not use thin aluminum
cooking utensils or allow aluminum foil to touch the
surface burners under ANY circumstances.
• Aluminum utensils - The melting point of aluminum is
much lower than that of other metals. Care must be taken
when aluminum pots or pans are used on the cooktop. If
aluminum pans are allowed to boil dry when using the
cooktop, the utensil may be damaged or destroyed.
To replace the interior oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. Press wire holder to one side to release the glass shield
that covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
back into place.
5. Turn power on at the main source (or plug the appliance
in).
6. The clock will then need to be reset. To reset, see Setting
clock in this Use & Care Guide.
21