Brother FAX-60 - Manual (Page 25)

To skip to the next message, press the MEMO button while a message is playing. The unit will
emit a 1 -second beep before the next message.
if you need to stop the playback of a caller's message or a memo, press MEMO and STOP
buttons during the playback or during the beeping between the messages or memos.
If you had to stop listening to recorded messages during a message-separating beep, and you
now wish to resume listening, you can do so in two different ways:
1. Pressing the MEMO button once will play back the messages from the top of the very
first message.
2. Pressing the MEMO and START/COPY buttons together will let you resume the
playback just before the point where you've stopped earlier.
If you had to stop listening to playback in the middle of a message —
1 . Pressing the MEMO button will start you off at the very beginning of the recorded
messages.
2. Pressing the MEMO and the START/COPY buttons will start you off with the
message which was interrupted.
D. Erasing the messages/memos
Make sure that the TAD switch is OFF.
To erase a message or a memo press the FINE/PHOTO and RECORD buttons simultaneously
while the message or memo is playing or during the beep following this message. You will hear a
1 -second beep and the message or memo will be erased.
To erase all messages or memos, press FINE/PHOTO and RECORD buttons when the message
or memo is not playing. You will hear a 3-second beep.
19
E. Remote operation of the TAD
The messages recorded on your FAX-60 TAD can be retrieved from any touch-tone telephone,
provided, you know the security code (to be described below in F). This is how the remote
operation works:
1. Dial the telephone number of your FAX-60 unit.
2. When you hear the OGM (your Outgoing Message), press the # button repeatedly until
you hear a short beep (1 second).
3. Dial in the 3-digit Security Code within 15 seconds of hearing the beep. If the code is
correct, you will hear a short beep (1 second). If the code is incorrect, you will hear a
series of short beeps. Try again!
IMPORTANT NOTE: If there are no messages on your TAD, you will hear a series of short
beeps.
Now, you are ready to request the FAX-60's TAD to perform some functions. These functions
and the remote commands needed to activate them are shown in the table below.