Not available on u.s. and canadian models), Accessory items – Pioneer VSX-452 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE OPERATING, ADJUST THE POSITION OF THESE SWITCHES
TWO VOLTAGE SELECTOR SWITCHES
Only multi-voltage models are provided with these switches. U.S.,
Canadian, European. U.K. and Australian models are not provided with
these switches.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Saudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the power
requirements of the destination. Check that they are set properly before
plugging the power cord into the household wall socket. If the voltage
is not properly set or if you move to an area where the voltage
requirements differ, adjust the selector switches as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust so that the tip of the groove points to the voltage
value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
CHANNEL STEP SWITCH
(Not available on U.S. and Canadian models)
The unit has been factory preset to the channel allocation for the area
in which it is to be sold. If these values are set incorrectly, the frequency
display may stop at the wrong frequency, resulting in an inability to
reproduce reception signals at their proper sound quality. For this reason,
be sure to confirm that the values are set correctly before first using
the unit.
[100 kHz/10 kHz] position;
Set to this position for areas with an FM reception step of 100 kHz,
AM 10 kHz.
[50 kHz/9 kHz] position;
Set to this position, for areas with an FM reception step of 50 kHz,
AM 9 kHz.
NOTE:
When unsure about the channel allocation for your area, consult your
dealer for correct information.
^CHANNEL STEP
oa
100kHz 4 TsOkHz
J
I-!
I
IFM
10kHz-
•9kHz
NOTE:
Both switches must be in the same switch
setting; otherwise, unit can be damaged.
ACCESSORY ITEMS
Power cord
oopo
aaoo
aaao
ooao
Remote control unit
4
<ARB1424>