0pq-j-j_|^p yg – Brother FAX-175 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
17
5.
Press START/COPY button to enter the selection.
6.
Now, you can change the factory setting of "0" to the optional setting of "1". To enter
"1", press FINE button once. Press START/COPY button to register this choice.
(Note that pressing theSTART/STOP button without pressing FINE/PHOTO button
beforehand, selects and registers a "0"). The unit will automatically print out:
**** DO
YOU WISH TO MAKE THE FOLLOWING CHANGE?
*******
*
*
NEW USER SWITCHES: 0000100
*
*
**************************0pQ-J-j_|^p yg*****************************
The START/COPY lamp will start to blink.
7.
If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 4 where you
can select this procedure all over by pressing the FINE/PHOTO button five (5) times
and then going throrough the rest of the procedure.
If your entries are correct, press the START/COPY button to complete the selection
of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other switches. To do so, you press START/COPY button again which
will bring you back to step 4 above and where you can use the FINE/PHOTO button to
select the desired switch. Choice (2) is to terminate the registration process by
pressing the STOP button.
NOTE: Your entries, e.g., the RTI/TTI and user switch, etc. can be verified by printing out the
SYSTEM CONFIGURATION LIST. We will explain how to do this in a later section.