Cub Cadet ST35 - Manual (Page 10)

9
REF NO. DESCRIPTION
1 Gear Case
2 Grip
3 Throttle Wire
4 Throttle Lever
5 Hanger
6 Shoulder Band (Standard on ST35)
1
2
3
4
5
6
7
8
9
10
11
12
PARTS DESCRIPTION
REF NO. DESCRIPTION
7 Engine
8 Head/Blade
9 Deflector
10 Stop Switch
11 Drive Tube
12 Loop Handle
• This unit can be dangerous and cause serious
injury if improperly used. To reduce injury risk to
operator, helpers and bystanders, read and
understand the Operator and Safety Manual.
• Blindness can occur from objedts that are thrown
or ricochet even with shield in place. Operators,
helpers and bystanders must wear eye protec-
tion, ANSI Z87.1 approved.
• Always wear hearing protection when operating
unit.
• Use caution when refueling hot engine. Never
refuel while engine is on.
• Prevent accidental contact with unit and any cuting
attachment. Maintain a 50 ft. (15 m) radius, DAN-
GER ZONE surrounding the operator. ONLY the
operator, dressed in proper protective clothing
should be in the DANGER ZONE.
• Beware of KICKOUT blade thrust when using
blades. Special precautions are necessary for
blade operation, see your Operator and Safety
Manual. ONLY install manufacturer approved
blades on Brushcutter models equipped with prop-
er blade shields, harness, blade collar, nut and cot-
ter pin.
• Blade/Cutting attachment does not stop immediately
after releasing throttle. Keep hands and feet clear of
blade/cutting attachment unless engine is shut off
and cutting attachment is not moving.
• INSPECT BLADES BEFORE USE.
• DO NOT USE DAMAGED, CRACKED, BENT, DULL
OR IMPROPERLY SHARPENED BLADES.
• Do not remove shields modify the unit or install
attachments or parts not approved by manufacturer.
Approved attachment information and replacement
Operator and Safety Manual are available from man-
ufacturer.
WARNING
kickout