Cub Cadet ST35 - Manual (Page 19)

18
MAINTENANCE
EMISSION PARTS MAINTENANCE CHART
Air Filter Clean X
21
Element Replace X
Spark Plug Check / Clean / Adjust X
20
Replace X
Carburetor Clean (*1) X
18,19
Overhaul (*2) / Replace (*3) X
PART MAINTENANCE BEFORE
USE MONTHLY or
50 HOURS USE THREE MONTHS or
150 HOURS USE SIX MONTHS or
300 HOURS USE YEARLY or
600 HOURS USE SEE
PAGE
(*1) • At an authorized Cub Cadet Commercial servicing facility to be charged.
(*2) • For consumer use / At an authorized Cub Cadet Commercial servicing facility to be charged.
(*3) • For commercial use / At an authorized Cub Cadet Commercial servicing facility to be charged.
NOTE:
Time intervals shown are a maximum. Actual use and your experience will determine the frequency of
required maintenance.
You should be charged for the cost of any required replacement except warranty replacement under
LIMITED WARRANTY and/or EMISSION CONTROL WARRANTY.
A. CARBURETOR ADJUSTMENT.
The carburetor is preset at the factory. This is the
optimum setting under the barometric pressure and
climatic conditions at the factory and is suitable for
most operating sites.
It ensures that your machine will run smoothly, be
fuel efficient, operate reliably and produce low
emissions.
If the engine runs unsatisfactorily at high altitudes
or at sea level, slight readjustment of the carburetor
may be necessary:
NOTE
Every unit is run at the factory and the carburetor is
set in compliance with EPA. In addition, the
carburetor is equipped with H and L needle
adjustment limiters that prevent settings outside
acceptable limits.
1. Check the air filter and clean it if necessary.
2. Check the spark arresting screen (if fitted) and
clean it if necessary.
3. Mount the cutting tool.
a. Nylon line trimmer head:
Trim lines to the correct length. (The lines must
extend as far as the line limiting blade on the
deflector.
4. Start the engine and adjust the idling speed
correctly with the idle speed adjusting screw
(Ref. I). The cutting tool must not rotate.
5. Warm up the engine.
I
L H