Vermont Casting Stardance SDV30 - Manual (Page 22)

22
Stardance Direct Vent/Natural Vent Gas Heater
20007065
Thermostat Connection (optional)
Use only a thermostat rated for 500 millivolts.
Check the table below for the appropriate gauge ther-
mostat wire to use for the length of lead required in your
installation.
Thermostat
Wire / Gauge Maximum Run
18 20 feet
16 20 - 40 feet
14 up to 60 feet
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4” female connectors.
2. Connect the thermostat wires to the valve. (Fig. 42)
Install the Front Plate
Hold the front plate by the window bars and lift it into
position, engaging the two steel tabs on the top corners
behind the adjacent bosses in the side plates. (Fig. 43)
Then seat the Front against the sides so the tabs at the
bottom lip engage with the notches in the stove legs.
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without also lifting
it .
ST474
Stardance
Front
10/3/00
Engage steel tabs
gehind the cast
iron bosses
Control Door
Bottom tabs engage
notch in the leg.
ST474
Fig. 43 Install the front plate.
This completes assembly of the Stardance stove.