Bose 901 - Manual (Page 10)

the RIGHT channel EQUALIZER OUTPUT terminal on the
Equalizer to the RIGHT or B channel INPUT terminal on
your power amplifier.
4. Similarly, use a second cable and connect the
LEFT channel EQUALIZER OUTPUT to the 1-EFT or A
channel INPUT terminal on the power amplifier,
5, Using a third cable, connect the RIGHT channel
EQUALIZER INPUT terminal on the Equalizer to the
RIGHT or B channel OUTPUT terminal on your nreamp
(the preamp terminal may adternatively be labeled PREAMP OUT
or OUTPUT TO AMPLIFIER).
6. Similarly, using a fourth cable connect the
LEFT channel EQUALIZER INPUT terminal to the LEFT
or A channel OUTPUT terminal on your preamp.
7, Connect the Equalizer power cord to an AC re­
ceptacle. You may prefer to use a receotacle on your
preamp so that the Equalizer will be automatically switched
on or off by the power switch on the preamp.
The Equalizer is now installed in your system. No other
connections should be made to the Equalizer. If you have a tape
recorder, it is connected to the preamp in the normal manner de­
scribed in the preamp and recorder manuals. THE REMAINING
STEPS SHOULD BE FOLLOWED TO INSURE PROPER INSTALLA­
TION AND OPERATION.
8. Place the TAPE switch on the Equalizer to the
NORMAL position. This switch should be left permanently
in this position when the Equalizer is connected as de­
scribed in this section. Place the three frequency contour
controls so they coincide with the indicated dots. These
are the “normal" positions of the controls.
9. Turn the Equalizer and the rest of the system on.
The pilot lamp in the Equalizer POWER switch should light.
- 9 -