Bose 901 - Manual (Page 6)

the Equalizer to the RIGHT or B channel TAPE INPUT
terminal on your preamplifier or receiver. (This pre­
amplifier termineil may alternatively be labeled TAPE
Pl-AYBACK or TAPE MONITOR,)
4. Similarly, using a second cable connect the LEFT
channel EQUALIZER OUTPUT terminal to the LEFT or A
channel TAPE INPUT terminal on your preamplifier.
5. Using a third cable, connect the RIGHT channel
EQUALIZER INPUT terminal on the Equalizer to the RIGHT
or B channel TAPE OUTPUT terminal on your preamplifier.
(This preamplifier terminal may alternatively be labeled
RECORDER OUTPUT.)
6. Similarly, using the fourth cable connect the LEFT
channel EQUALIZER INPUT terminal to the LEFT or A
channel TAPE OUTPUT terminal on your preamplifier.
7. Connect the power cord from the Equalizer to an
AC receptaclel You may prefer to use a receptacle on
your preamplifier or receiver so that the Equalizer will be
automatically switched on and off by the power switch on
the preamplifier or receiver.
THE NEXT 5 STEPS ARE TESTS WHICH MUST BE PER­
FORMED TO INSURE PROPER OPERATION AND CORRECT
INSTALLATION.
8. Place the TAPE switch on the Equalizer to the
NORMAL position. Place the three frequency contour con­
trols so they coincide with the indicated dots. These are
the "normal" positions of the Equalizer controls.
9. Place the TAPE MONITOR or TAPE FUNCTION
switch on your preamplifier to the NORMAL or OUT position.
10. Turn on the entire system except for the Equalizer,
which should be turned off.
11. Play your system as you normally would using a phono­
graph or AM-FM source (NOT a tape recorder) to be sure it is
- 5 -