Pro501axl accessories, To connect the cigarette lighter adapter plug, Attaching the magnetic mount antenna – Uniden PRO501XL User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRO501AXL Accessories
To connect the Cigarette Lighter Adapter Plug:
IMPORTANT:
The Cigarette Lighter Adapter Plug is designed to be used ONLY with
negative ground \rehides. Do not attempt to operate the unit with the
Adapter Plug connected to a positive ground vehicle.
1. Remove the screw from the top half of
the plug shell (Be careful not to lose
the hex nut).
2. Carefully separate the two halves
of the plug shell.
wire end.
4. Crimp the terminals onto the wire
ends as shown.
Crimp on V№«
Crfrrip on Irtiulodkin
Blodt
FM
5. With the wires attached, insert the
terminals into the plug shell.
Note The black wire is inserted in the
section of the shell marked
negative (-). The
red
wire is
inserted into the section of the
shell marked positive (+).
6. Join the two halves of the plug shell. Secure the plug shell with the screw and hex nut.
Attaching the Magnetic Mount Antenna
1. Place the antenna in a convenient location on your vehicle.
2. Route the antenna cable through your vehicle’s window, door, or other opening into
the interior of the vehicle.
3.
Attach the antenna cable to the terminal on the rear of the
PRO501 AXL.
Note: Be sure to route the antenna where it will not interfere with the cperafon of
your vehicle.