Uniden PRO501XL - Manual (Page 9)

Troubleshooting
If the PRCS01XL does not perform to your expectations, please try the troubleshooting
suggestions listed below.
Problem Suggestion
Unit does not power on. • Check the winng connections.
• Check the in-line fuse.
• Check the vehicle electrical system.
Poor reception. • Check and adjust the SQUELCH.
• Check the antenna connections.
Weak Transmission. • Check the antenna connections.
Servicing Your CB
If you determine that service is necessary, contact your local dealer or return the unit
in its original carton to Uniden - Service Division Ship the item with a brief and
concise description of the problem, your name, address, a telephone number where
you can be reached during working hours and a copy of the original purchase receipt
to the address listed in the warranty (at the end of this manual)
Technical information, diagrams, and charts are available upon request. It is the user's
responsibility to see that this radio is operating at all times in accordance with the SMA
Citizens Band Radio Service regulations. We highly recommend that you consult a qualified
radiotelephone technician for service and alignment of this radio.
When ordering parts, please specify the correct model number and serial number of this
radio.
Please refer to the "WARNING" information at the front of this manual.
Care and Maintenance
The PR0501XL is designed to give you years of trouble-free service. There are no
user-serviceable parts inside and, except for the fuse in the DC power cord, no
maintenance is required.
Note: Do not expose the unit to moisture. Rain, dew, road splash, or other liquids
may damage the internal components.
Replacing the Fuse in the DC Power Cord
The in-line fuse holder contains a 2-anpere fuse to protect the radbfrompowersurges.
To inspect or replace a blown fuse:
1. Press the ends of the fuse holder together and twist counterclockwise. Carefully
separate the two halves.
2. Remove the fuse and inspect. If blown replace it with the same type.
3. Replace fuse inside the holder and reassemble the two halves by pressing the ends
together and twisting clockwise.