Bose X - Manual (Page 11)

6. Route the boom cable to the earcup on
which the boom is to be installed. If the
boom is to be installed on the right earcup.
do not route the cable sharply from the
molded block in the center of the head-
barxJ. Route the cable in a small loop to ttte
left of this block, then in back to the right
{see Rgure 12).
Route the cable to the left and then in ba<*
lothe right of the block.
a
9.
7. Place the connector to the Side of the
molded block closest to the earcup on
which the microphone will be installed.
Thread the mic cable through the groove
in the pivot block.
Wrap the boom and cable around the
earcup cable three times by passing the
boom between the yoke arm and earcup
cable, from back to front.
10. Snap the boom firmly into the clip so that
one of the rectangular faces on the
coupling is visible v;hen the boom snaps
into place (see Figure 13). Be sure that the
word “TALK" on the micrc^hone faces the
mouth
Figure 13
Make sure the rectangular face shows when
the boom snaps into place.
11. Replace the foam pad and wrap the
cover around the headband with the
opening to the rear. Sr^ap it at both er>ds
and seal the Velcro (see Figure 9 on
page 7).