Bose X - Manual (Page 9)

Pivot
Block
Figure 7
Unwind the cable and remove it
from the groove.
3. If you are changing it from right side to left,
route the cable in a small loop to the right
of the nrKsided block in the center of the
headband. then to the left and along the
back of the headband (see Figure 8). This
step prevents excessive strain on the
cable.
Figure 8
Route the cable in a loop to prevent strain.
4.
5.
6 .
Thread the cable through the groove in the
back of the other pivot block.
Wrap the cable around the other earcup
cable by passing the end betv.ieen the
yoke arm and earcup cable twice, from
back to front.
Place the foam pad in the headband cover
(see Figure 9). Wrap the cover around the
headband with the opening toward the
rear. Smoofri the Velcro down and snap
the cover together at both ends.
FoamPa<3
Headband
Cover
Figure 9
Replace the headband cover and foam pad.