All band mode, Individual band mode, 2-5. a.b.c.(automatic band change) – Kenwood TM-741A User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To clear both programmed limits simultaneously,
turn the Power off ,then;
ALL BAND mode
Press and hold the VFO key, then turn the Power
switch on (VFO RESET See page 30).
INDIVIDUAL BAND mode
Press and hold the VFO key and the BAND SEL key
for the band you want to clear, then turn the Power
switch on.
You can reprogram either limit independently by fol
lowing the appropriate instructions above.
2. As soon as a signal is received on any band, the TX
circuit will become active on that band.
(
l O H S
, ^ u n n n f f ^ . n n n n
I ' i l . U U U W u . u u u
3.
If you press the PTT switch,
The A.B.C. function will be released. The band
remains TX band.
4-2-5. A.B.C.(Automatic Band Change)
The A.B.C function allows you to exchange the RX band
to the TX band automatically whenever a signal is
received and the squelch is open.
1. Press the F key and then press the MUTE/ABC key.
The A.B.C. indicator will light on the display.
If the PTT switch is not pressed,
Within 2 seconds after the signal goes off, the band
will be returned to RX band.
If you press the BAND SEL key.
The A.B.C function will be released.
( J j
A.B.C.
(^MUTE^
' ^ . u n n n
. , . , n n n n
l U l D I H i . u u u ' i H u . u u u
24