Remove the cooling fan assembly, Remove the spacer, D). insert the new band unit – Kenwood TM-741A User Manual
Page 72
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Remove the cooling fan assembly.
Disconnect the
conector.
Remove the 4 screws
securing the fan case.
Remove the fan case.
0
REmove the spacer.
Remove the 2 long screws securing the spacer.
Remove the spacer.
72
®. Be sure to unplug the dc cable before
removing the terminal plate.
0 Remove the 4 screws
from the both sides of
the present 2 units,
d) Remove the plate.
d). Insert the new band unit.
0 Insert the new band unit as shown in the
accompaning diagram.
Connector
Advertising