Low battery warning, Select the component to be registered, O ^ o – Kenwood 1080VR User Manual
Page 44: Getting the most from your remote control, I г i i, Г n t
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting the most from your remote control
1080VR (En/Kj
$
The remote control supplied with this receiver is also capable of controlling components from a variety of manufacturers once
^ you register the appropriate setup codes into the remote control unit.
^ Refer to "Remote operation of other components" for details about the operations available for each component. -
,9 * \zvhen registering setup codes for KENWOOD audio components which are connected to this unit by system control cords, use the
following codes to insure proper system control operation: Cassette: 7000, CD: 8099, MD: 9000.
-
To control other KENWOOD components (VCRs, LD players, audio components not connected with system control cords, etc.) follow
the procedure described below.
Low battery warning
Replace all four batteries with new ones when you notices shortening of the distance from which the remote control will operate or if the remote control
blinks 5 times when you push a key. The remote control is designed to retain set up codes in memory while you change batteries.
2
О
C?
§»
3
Find the setup code of the component to he
registered.
Refer to the setup code lists to find the setup code for the
component to be registered.
-
3
£
Example: To register a CD made by KENWOOD, you would
enter"8037"
If you purchase a new component that is not covered by the
setup code list, you can use the FutureSet upgrade feature.
Hold down the ENT key until the backlight
flashes twice and remains lit.
Select the component to be registered.
j..
Press the VIDEO, AUDIO, or TV
key repeatedly to select the de
sired component.
AUDIO
o ^ o
Input
Component
Maker
Code
Key
(CD)
CD player
KENWOOD
веге, 8037
AUDIO
VIDEO 1
VIDEO 2
VIDEO 3
TAPE/MD
CD
PHONO
-
TV1
-
TV2
-
CABLE
•At this time all inputs become available regardless of any earlier
registration.
Perform each of the following steps within
5 seconds.
VIDEO
key
V VIDE01 (SAT)
2 VIDE02 (LDI
1— 3 VIDE03 (VCR)
AUDIO
key
r* (i CD (CD)
2 TAPE/MD
(TAPE)
3 PHONO
TV
key
1 TV1
2 TV2
3 CABLE
[
• Example : To register the component connected to the VIDEO 1 jacks,
select "VIDEO 1 (SAT)".
Г n T
I г I I