Toshiba MA-216-100 SERIES - Manual (Page 53)

EOl-11003
9. READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the the key operations to Issue those reports. The
contents of the X and Z reports are the same if both are available, except that:
1) Symbol X for X (read) reports, and Z for Z (reset) reports are printed as the header,
2) A reset count is printed near the end of a Z report (but not on X reports).
3) All the resettable counters and totals will be reset on a Z report issuance, while they will not
be reset on an X report issuance. Therefore, X reports may be taken at any time and any
number of times during the day or at the end of the day.
TABLE OF X AND Z REPORTS
* DAILY READ AND RESET
DAILY READ
DAILY RESET (DEPARTMENT +
FINANCIAL + CLERK + GROSS PROFIT)
[ATA'Ll 52
PLU READ AND RESET
ALL PLU READ
ALL PLU RESET
ZONE PLU READ
ZONE PLU RESET
X
z
X
z
H [PLU]
I Zone-Start I
_I i PLU Code r
54
CLERK READ AND RESET
INDIVIDUAL CLERK READ
INDIVIDUAL CLERK RESET
X
z
set the required Clerk
Key to ON -► 1 [AT/TL]
55
HOURLY RANGE READ AND RESET
HOURLY READ
HOURLY RESET
H
10 I AT/TL] 56
MEDIA-IN-DRAWER READ [#1 (or [#/CID], [#/NS]) 57
*GT READ AND RESET fACCUMULATED
DAILY)
GT READ
GT RESET
X
z 20 [AT/TL] 58
- 5 0 -