3)to finish configuring the alarm settings, To restore the previous configuration, To configure other alarm settings – Toshiba IK-WB11A User Manual
Page 57: Configuring external alarm settings, 3 ) t o finish configuring the alarm settings
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
( Available Settings when "Preset" is Selected;
Preset No. (number of the preset which images the camera
shows when an external alarm has gone off)
1
to
10
Resume Function (returns the lens to the position where it was
when the alarm went off)
ON : When a fixed period of time elapses after the lens moved in
response to an alarm, the lens returns to the position where
it was when the alarm went off.
OFF : After the lens moved in response to an alarm, the lens stays
still at the position of the selected preset.
Resume Time (period of time until the Resume function starts)
10, 30, 60 seconds
^NOTE
• The "Preset No.," "Resume Function," and "Resume Time" settings are only
valid when "Preset" is selected for "Associate to P/T Operation."
• Detection range of the motion sensor is the range the camera is monitoring. If
there were some movements in where out of the camera monitoring range, the
movements cannot be detected.
3 ) T o finish configuring the alarm settings,
click the
button below the settings
The changes are saved.
To restore the previous configuration,
click the I
reset
button below the settings
The changes are discarded.
To configure other alarm settings,
proceed to the next section
-1
o
a .
c
m
0
)
3"
(D
-1
№
57
save