Toshiba MA-1190 - Manual (Page 92)

Fig. 7
INSTALLING THE JOURNAL PAPER
1. Turn the Mode Lock to the *'REG" position.
2. Remove the Receipt Cover by pulling it
upward (Fig. 1 on the previous page).
3. Remove the Journal Winding Reel.
4. Set the new paper roll in the journal roll
holder (righthand side) with the paper end
fed from the bottom (Fig. 7).
5. Insert the paper end into the journal
inlet while holding the [JF] key pushed
down (Fig. 8).
6. When the paper comes out of the journal
outlet for approx. 20cm (or 8 inches),
release the [JF] key (Fig. 9).
7. Wind up the paper end on the Journal
Winding Reel two or three times as shown
in Fig. 10.
8. Set the Journal Winding Reel to the holder
(Fig. 11).
9. Attach the Receipt Cover (Fig. 12).
10. Depress the [C] key before starting
operations.
REMOVING THE JOURNAL PAPER
1. Remove the Receipt Cover by pulling it
upward (Fig. 1 on the previous page).
2. Depress the [JF] key to wind up enough
portion of the journal paper, and then
tear off the paper, holding the Journal
Winding Shaft.
3. The wound-up portion of the paper can
easily be removed from the Winding Shaft
by pulling it side way (Fig. 13).
4. If enough paper remains on the roll,
follow Steps 6 through 10; if paper is
running out, follow Steps 1 through 10 in
"INSTALLING THE JOURNAL PAPER" above.
Fig. 10
- 88 -