Toshiba MA-1190 - Manual (Page 93)

REPLACING THE INK RIBBON
Ribbon Cover
Fig. 14
When the receipt and journal print is too
light, replace the ink ribbon in the
following manner.
Reaoving the Ribbon
1, Turn the Power Switch to OFF.
2. Remove the Ribbon Cover. (Press the side
inward and the hook will be unlocked.)
(Fig, 14)
3, Open the Cutter Block by pulling it upward
while pressing the leftside lever outward.
(Fig. 15 and Fig. 16)
4. Remove the Ink Ribbon by lifting up the
ribbon spools (Fig. 18).
Installing a new Ribbon
1. Set the ribbon spools so that the ribbon
will be wound to the direction shown by
the arrows respectively. Meanwhile, let
the ribbon go through the Ribbon Guides,
the Tension, and the Dot Head Ribbon Guide
(Fig. 18 and Fig. 19).
2. After setting, make sure that the ribbon
properly goes through respective parts
required, by turning a ribbon spool
several turns.
3. Close the Cutter Block. Make sure that
the leftside lever has locked the block.
4. Turn the Power Switch to ON.
5. Depress the [C] key. The flickering
display will stop and be lit steadily.
6. Attach the Ribbon Cover.
- 89 -