Programming the remote to control a dvd player, Using the universal remote control, Programming the remote to control an rca brand – RCA RV-9978 User Manual
Page 21: Receiver
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE UNIVERSAL REMOTE CONTROL
PROGRAMMING THE REMOTE
TO CONTROL A DVD PLAYER
The remote is preprogrammed to control a RCA DVD
player. A few of the remote buttons used with a DVD
player are shown below. You may want to experiment
with other buttons on the remote to see if they work
with your DVD player.
Receiver Remote
INFO
GO BACK
CLEAR
MENU SELECT
MOVE Arrows
PLAYLIST
ENTER
(works like)
DVD Remote
INFO
GO BACK
CLEAR
MENU SELECT
ARROWS
PLAYLIST
ENTER
PROGRAMMING THE REMOTE
TO CONTROL AN RCA BRAND
DSS*
RECEIVER
The remote is preprogrammed to control the RCA
brand DSS* receiver, A few of the remote buttons used
with the RCA brand DSS* receiver are shown below.
You may want to experiment with other buttons on
the remote to see if they work with your receiver.
Receiver Remote (works like) RCA brand DSS*
Remote
INFO
GO BACK
ANTENNA
CLEAR
MENU/SELECT
MOVE ARROWS
SELECT/DISPLAY
PREV CH
TV/SAT
CLEAR
MENU
ARROWS
PROGRAMMING THE REMOTE
TO CONTROL A SATELLITE RECEIVER
1. Turn on the satellite receiver.
2. Look up the satellite receiver brand and
corresponding code number(s) in the code list on
the right.
3. Press and hold the SAT*CABLE button on
the remote,
4. Enter the three-digit code from the code list.
5. Release the SAT*CABLE button, then press POWER
or CH + or CH - to see if the receiver responds to
the remote's commands. If it doesn't, try pressing
SAT*CABLE, then POWER again,
6. Repeat steps 3 through 5 using the next code listed
for the brand of your receiver until the receiver
responds to the remote commands.
------
This remote may not operate all models of the
brands shown.
If a battery is removed from the battery
compartment of the remote control, all control key
functions will return to the original mode.
To program the LD*VCR2 button to control a second
VCR, follow these steps but use the LD-VCR2 button
instead of the VCR button.
The buttons on the remote may not work on all
other brands of components. Experiment with the
remote and your components to see which buttons
work.
DSS* is a registered trademark of DIRECTV, INC., a unit of GM Hughes Electronics.
21