Chrysler 2009 Aspen - Owner Manual User Manual

Page 211

Advertising
background image

2. Fully depress the accelerator pedal slowly three
times within 10 seconds.

3. Turn the ignition switch to the OFF/LOCK position.

NOTE:

If the indicator message illuminates when you

start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.

16. Odometer
The odometer shows the total distance the vehicle has
been driven.

U.S. federal regulations require that upon transfer of
vehicle ownership, the seller certify to the purchaser the
correct mileage that the vehicle has been driven. There-
fore, if the odometer reading is changed during repair or
replacement, be sure to keep a record of the reading
before and after the service so that the correct mileage can
be determined.

17. Fog Light Indicator

This light shows when the fog lights are ON.

18. Electronic Stability Program (ESP) Indicator Light

The yellow Electronic Stability Program (ESP)
indicator light in the speedometer area illumi-
nates with the key in the ignition switch turned
to the ON/RUN position and it should go out

with the engine running. The ESP is also combined with
the Traction Control System (TCS), when the

ЉESP/TCS”

Indicator Light

Љ starts to flash as soon as the tires lose

traction and the ESP system becomes active. The

ЉESP/

TCS Indicator Light

Љ also flashes when TCS is active. If

the

ЉESP/TCS Indicator LightЉ begins to flash during

acceleration, ease up on the accelerator and apply as little
throttle as possible. Be sure to adapt your speed and
driving to the prevailing road conditions. The “ESP/TCS
Indicator Light” becomes illuminated when the ESP-Off

UNDERSTANDING YOUR INSTRUMENT PANEL

209

4

Advertising