Chrysler 2009 Sebring Convertible - Owner Manual - Manual (Page 274)

Brake/Transaxle Interlock System
This system prevents you from moving the shift lever out
of PARK and into any gear unless the brake pedal is
pressed. This system is active only while the ignition
switch is in the ON position. Always press the brake
pedal first, before moving the shift lever out of PARK.
NOTE: If a malfunction occurs, the transaxle will not
shift out of PARK. Battery power is required to release the
Brake/Transaxle Interlock system. However, an override
system allows you to shift out of PARK in case of loss of
power. To activate the override system:
• Firmly apply the parking brake.
• Insert the ignition key into the ignition key lock
cylinder and rotate it to the ON position.
• Remove the cup holder liner.
• Insert a key, screwdriver, or finger into the hole at the
front of the cup holder and push and hold the manual
override release lever forward.
• While holding the release lever forward, move the
shift lever from PARK to NEUTRAL.
• Release the manual override.
NOTE: If this occurs, even if the override is successful,
it is recommended that you visit a dealer at your earliest
possible convenience. Your dealer has diagnostic equip-
ment to determine if the problem could recur.
272 STARTING AND OPERATING