Canadian/gate operator programming – Chrysler 2013 200 Convertible - Owner Manual User Manual
Page 200
![background image](/manuals/671761/200/background.png)
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink
button you wish to pro-
gram while keeping the HomeLink
indicator light in
view.
3. Continue to press and hold the HomeLink
button,
while you press and release (“cycle”), your hand-held
transmitter every two seconds until HomeLink
has
successfully accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly when
fully trained.
4. Watch for the HomeLink
indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
198
UNDERSTANDING THE FEATURES OF YOUR VEHICLE