COMP Cams 3201 Chevrolet Timing Chain - Manual (Page 3)

Part #172
Revised 7/01/05
Competition Cams, Inc
3406 Democrat Rd.
Memphis, TN 38118
(901)795-2400 FAX (901)366-1807
www.compcams.com
locking tabs if you are using the cam locking plate. If camshaft bolts loosen up, severe engine damage
can result. A good thread locking compound should be used on all bolts. Make sure that the engine oil
has a clear path to the timing set through the lifter valley drain holes or some other means. Timing sets
require plenty of oil to survive. Pour plenty of Pro Cam Lube (Part #153 or #154) over the entire
timing set. The proper lube will protect your timing set during final assembly and initial start up.
Step 3 – Final Assembly
Install the timing cover and gasket. COMP Cams ® offers a two piece front cover (Part #210 for Small
Blocks and #212 for Big Blocks) that simplifies camshaft timing changes without disturbing the oil
pan seal. Erratic ignition timing problems caused by timing cover flex will also be eliminated. This
cover offers all strength and rigidity necessary for easy use, and no bothersome oil leaks. Install the
harmonic balancer using your installation tool (Part #4920). Never use a hammer to install your
balancer. This can cause serious damage to the balancer and internal parts.
Limited Warranty
Competition Cams, Inc. warrants that all of its products are free from defects in material and
workmanship, and against excessive wear for a period of (1) one year from the date of purchase. This
limited warranty shall cover the original purchaser.
Competition Cams, Inc.’s obligation under this warranty is limited to the repair or replacement
of its product. To make a warranty claim, the part must be returned within (1) one year of purchase to
the address listed below, freight prepaid. Items covered under warranty will be returned to you freight
collect.
It is the responsibility of the installer to ensure that all of the components are correct before
installation. We assume no liability for any errors made in tolerances, component selection, or
installation.
There is absolutely no warranty on the following:
A) Any parts used in racing applications
B) Any product that has been physically altered, improperly installed or maintained;
C) Any product used in improper applications, abused, or not used in conjunction with the
proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose. There are
no warranties, which extend beyond the description of the face hereof. Competition Cams, Inc. will
not be responsible for incidental and consequential damages, property damage or personal injury
damages to the extent permitted by law. Where required by law, implied warranties or merchantability
and fitness are limited for a term of (1) one year from the date of original purchase.
This warranty gives you specific legal rights and you may also have other legal rights, which vary from
state to state.