COMP Cams 13702-KIT Rocker Arm Trunion - Manual (Page 3)

COMP Cams ®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #COMP4-126
Revised 4/10/12
7. Picking up the rocker body, place the other included assembly washer beneath it. Ensure that
the trunion fits through the center opening of the assembly washer.
8. Then place the rocker, with trunion and washers on the top and bottom, back on the press and
press against the top washer ensuring that everything stays lined up until the top bearing is
flush with the rocker arm body.
9. Using a set of snap ring pliers, install the included snap rings on both sides of the rockers.
10. Repeat this process on the remaining 15 rocker arms.
11. Install the rocker arms using the included new bolts. Make sure
to install the bolt sitting on the flat surface of the trunion.
Torque to 22 ft./lb. following the OEM installation procedure.
Social Media
Stay up-to-date with the latest COMP Performance Group
™
company and product
information by following us on any of our social media platforms.