Cabletron Systems SEHI-22/24 - Manual (Page 61)

Finding a Source Address 5-11
Source Addressing
Figure 5-4. The Port Source Address Traps Window
2. Click on the appropriate selection in the Trap Status field to enable or disable
traps for the selected port(s), as desired.
3. Click on to save your changes.
Finding a Source Address
You can use the button to locate a source address in the list by the
module and port through which it is communicating with the SEHI. This feature
is especially useful when your device is very busy and your source address table
is quite large.
NOTE
Some entries in the Port Source Address Traps window may list port numbers 25 or 26;
port 25 represents EPIM 1, and port 26 represents EPIM 2.