Defibtech AED Training Equipment - Manual (Page 6)

2 DAC-515E-EN-BD
2 Training Equipment Components & Preparation
Note: The following section 2.1 applies to both the Standalone AED Trainer
and the Training Battery Pack System. After reviewing this section, please refer
to either section 2.2 or section 2.3 as appropriate to your specific training
equipment.
2.1 Common Components
2.1.1 DBP-RCX series Training Battery Pack
The rechargeable DBP-RCX series Training Battery Pack is a component of both
the Standalone AED Trainer and the Training Battery Pack System.
Before use, the Training Battery Pack should be charged using the supplied battery
pack charger (DTR-2XX series). The battery will fully charge in 12-14 hours.
Note: Avoid overcharging for longest battery life – when proper charging
procedures are followed, the battery pack should have a life of approximately 200
charge/discharge cycles.
The Training Battery Pack does not require a 9V battery.
Note: If a Training Battery Pack is installed in an AED or AED Trainer with a 9V
battery, the ASI indicator light in the upper right corner of the AED will blink red
and a warning chirp will be generated to warn the user that the AED is not capable
of operating as a rescue defibrillator.
2.1.2 DTR-4XX series Remote Control
The DTR-4XX series Remote Control is supplied with the Standalone AED Trainer
and is an optional component of the Training Battery Pack System.
Use of the Remote Control during training exercises is optional when using either
equipment option.
The Remote Control requires two AAA batteries. Insert the batteries into the
battery compartment in the back of the Remote Control. No other setup of the
Remote Control is required.
2.1.3 Training Pads
One set of adult training pads (DDP-101TR) is supplied with the Standalone AED
Trainer and is available separately for optional use with the Training Battery Pack
System.
Training pads are available as complete sets (pads, wire, & connector assemblies)
and as economical replacement pads in both adult and pediatric sizes. The
replacement pads attach (with hook and loop fasteners) to the reusable wire &
connector supplied with complete pad sets.
Part numbers for these pad options are: DDP-101TR (Complete adult pad set),
DDP-105TR (5-pack adult replacement pads), DDP-201TR (Complete pediatric pad
set), DDP-205TR (5-pack pediatric replacement pads).