Citizen Systems CBM-231 User Manual
Page 38
CBM-230/231 User’s Manual
33
CITIZEN
(8) Specifying the bit Image (ESC * m n1 n2 D1 ~ Dn)
Code : [1B]h + [2A]h + m + n1 + n2 + Dn
* {m= Bit image mode (refer to the table below)}
{0
≤
n1
≤
FF}
{0
≤
n2
≤
02}
The data is described with the hexadecimal code.
Prints the data in the form of bit image in accodance with the bit image mode specified by "m".
•
The number of bit printed is divided by 256, and n2 and is assumed to be a quotient, and n1 to be the
remainder.
•
The total number of dots printed in the form of bit image is n1 + (256
×
n2).
•
When the bit image is entered beyond a 1 dot line (576 dots) position, the surplus data is discarded.
•
For the bit image data (Dn), the bit to be printed is set to "1" and that not to be printed to "0".
•
The following table shows the bit image mode.
(
) = For 42 columns spec.
Vertical
Horizontal
m(Hex)
Mode
No.of Dots
Dot Density
Dot Density
Max. No. of Dots
0
8-dot single density
8
67 DPI
101 DPI
288 (252)
1
8-dot double density
8
67 DPI
203 DPI
576 (504)
20
24-dot single density
24
203 DPI
101 DPI
288 (252)
21
24-dot double density
24
203 DPI
203 DPI
576 (504)
•
When the value set for "m (bit image mode)" dose not meet the condition, the data subsequent to n1 is
processed as printing data.