Citizen Systems CBM-231 - Manual (Page 55)

CBM-230/231 User’s Manual
50 CITIZEN
•
When this command is accepted during macro definition, it means cancellation of macro definition.
When this time done, the definition is cleared.
•
Nothing is executed when the macro has been undefined or n1=0 has been set.
•
When n3 = 1 is set and the macro is being executed, the paper cannet be fed by the paper feed switch.
(39) Data input control (ESC = n)
Code : [1B]h + [3D]h + n
* {0
≤
n
≤
FF} The data is described with the hexadecimal code.
Selects the device where data input from the host is effective.
•
Each bit of "n" has the following meanings.
Value
Bit Device
0 1
0 Printer Disabled Enabled
1 Undefined
2 Undefined
3 Undefined
4 Undefined
5 Undefined
6 Undefined
7 Undefined
•
When the printer id disabled, this printer discards all receive data until it is enabled by this command.
•
Even if the printer is disabled, it may be placed in the busy state by printer operation.
•
The initial value of "n" is "1".
(40) Aligning the characters (ESC a n)
Code : [1B]h + [61]h + n
* {0
≤
n
≤
2} The data is described with the hexadecimal code.
Aligns all printed data in one line to a specified position.
•
Justification listed in the following table is performed depending on the value of "n".
n (Hex) Position
0 Left alignment
1 Center alignment
2 Right alignment
•
Effective only when this is entered at the beginning of the line.
•
The initial value of "n" is "0".