Drawmer DS201 Dual Noise Gate - Manual (Page 3)

SAFETY CONSIDERATIONS
CAUTION - MAINS FUSE
TO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITH THE
SAME TYPE, WHICH MUST BE A CLASS 3, 230 VOLT, TIME DELAY TYPE,
RATED AT 32mA WHERE THE MAINS INPUT VOLTAGE SWITCH IS SET TO 230
VOLTS AC. AND 63mA WHERE THE MAINS INPUT VOLTAGE IS 115 VOLTS AC.
ALL FUSES MUST COMPLY WITH IEC 127-2.
THE FUSE BODY SIZE IS 20mm x 5mm.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED MAINS
CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING. REFER ALL SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
INSTALLATION
This product is designed for standard 19" rack mounting and occupies 1U of rack space.
Use four M6 pan head screws to secure the unit into the rack. Fibre or plastic washers may
be used to prevent the front panel becoming marked by the mounting bolts.
! Care should be taken in the choice of positioning. The unit should not be mounted
where other equipment obstructs the normal air flow. The unit should not be situated
near any heat source, such as a radiator, stove or a high power amplifier that would
generate heat.
! The DS201 should not be operated near any water or in a location where moisture
might be present.
-3-