Power connection – Drawmer DS201 Dual Noise Gate User Manual
Page 5
POWER CONNECTION
The unit will have been supplied with a power cable suitable for domestic power outlets in
your country. For your own safety it is important that you use this cable. The unit should
always be connected to the mains supply earth using this cable, and no other.
If for some reason the unit is to be used at a mains input operating voltage which is different
to that as supplied, the following procedure must be carried out.
1:
Disconnect the unit from the mains.
2:
Remove the two self-tapping screws that hold the voltage selection switch
cover-plate onto the rear panel.
3:
Remove the cover plate and slide the switch fully to its opposite end.
4:
Rotate the cover plate one half turn, (180E) and refit the two screws.
5:
Replace with a correctly rated fuse for the selected operation voltage.
6:
Re-connect to mains power source.
Never disconnect the earth from the mains supply
-5-